User Support Forum

We installed V9, up from v8.5 last Friday. We have Powerchurch networked to 13 computers in the offices here.

Once installed, it was necessary to remove the network setup for each of the remote users accessing 8.5 and re-install each one pointing the V9.

None of the secondary users have full access, only read-only. How do I change their access authority so they have full read write access?

In preferences/password, I enabled passwords and set up a user and checked the three columns that individual would need to have full access to. When I go to the users station and log onto powerchurh and select their user, they cannot initialize since the program says it cannot complete due to the read only status. The program then terminates for the remote user...

If you just upgraded from the CD, you need to get the maintenance release with the new/replaced netsetup9.

Check out the maintenance release page by going to Help -> About and selecting Maintenance Release.

Hope this helps.

Jeff

Actually, the issue in this case was the network resource was shared read-only. Once that was set to full access, the error went away. There was just confusion with that vs. setting up passwords within the program itself.