Page 1 of 1
OLE ERROR CODE
Posted: Sat Dec 30, 2006 8:45 am
by farmer11
Now when I try to backup or restore all I get is this code. I think it means that the program does not know that the backup it there. What do I do?
Is this where I run the install disc again?
Thanks
Re: OLE ERROR CODE
Posted: Sat Dec 30, 2006 12:58 pm
by NeilZ
farmer11 wrote:Now when I try to backup or restore all I get is this code. I think it means that the program does not know that the backup it there. What do I do?
Is this where I run the install disc again?
Thanks
You didn't say what version of Powerchurch you're using, which would help in troubleshooting.
However, quick question. You get this when you start a backup ?? What type of media are you backing up to??
Posted: Mon Jan 01, 2007 8:03 pm
by Zaphod
Neil is right, we may need more information to help sort this out. However, you can run the netsetup file located in the main PowerChurch directory (PCPLUS9, PCPLUS10, etc) and that will reinstall many of the files PowerChurch uses. That may actually fix whatever the problem is.
backup
Posted: Fri Jan 05, 2007 10:26 am
by farmer11
I am using version 9. I did go ahead and rerun the install disk and now it can see the disc or jump stic that I was using to back up the data.
Thanks