Page 1 of 1
Incomplete Report was generated
Posted: Tue Sep 28, 2021 1:28 pm
by Barbara Gooden
I was asked to generate a report with all of the widows and widowers in the church. One widow was left out. I went back and checked her marital status and it was listed as "widow/widower." How can I get this report to include her name?
Re: Incomplete Report was generated
Posted: Tue Sep 28, 2021 2:08 pm
by NeilZ
Barbara Gooden wrote: ↑Tue Sep 28, 2021 1:28 pm
I was asked to generate a report with all of the widows and widowers in the church. One widow was left out. I went back and checked her marital status and it was listed as "widow/widower." How can I get this report to include her name?
Check to see if there are other filters on the report, that may have caused this issue. The usual reason is that the spouse was a member, but she was not and wasn't listed as a 'family member', or some such.
Re: Incomplete Report was generated
Posted: Tue Sep 28, 2021 2:18 pm
by Zorak
Another common thing that will keep people from showing up in reports is the "Include in Membership Module Reports" checkbox option on the family record. Verify that this option is checked on the Integrated Data Entry screen. It is found on the Contact tab along the right side of the form.