Page 1 of 1
Networking Data
Posted: Thu Oct 27, 2005 9:38 am
by melloby
Hi,
I have PCP+ on a network with two desktops and a laptop. How can I get the current data on the network on a remote system offsite?
I have another PC at a remote site.
Thx
Melloby
Posted: Thu Oct 27, 2005 10:49 am
by Zaphod
There's not a way to do this natively within PowerChurch, but there are some third party programs where folks have reported some success when using them. The first that comes to mind is
http://gotomypc.com. You can also set up Terminal Services too, if you have the resources for that.
I'm pretty sure there's a thread here on the board where this has actually been discussed already.
EDIT: Actually, there are several:
http://www.powerchurch.com/forum/viewtopic.php?t=943
http://www.powerchurch.com/forum/viewtopic.php?t=718
http://www.powerchurch.com/forum/viewtopic.php?t=720
Networking Data
Posted: Thu Oct 27, 2005 11:03 am
by melloby
Hi Zapod,
Thx for your reply.
Would this work, if I backup the data on the network. Then I install the data on my remote pc thru the utilities module of PCP+?
Thx
Tamico
Re: Networking Data
Posted: Thu Oct 27, 2005 7:27 pm
by NeilZ
melloby wrote:Hi Zapod,
Thx for your reply.
Would this work, if I backup the data on the network. Then I install the data on my remote pc thru the utilities module of PCP+?
Thx
Tamico
It will work, as long as you don't use the remote PC to do any updates otherwise you would be out of sync.
FWIW ... we use GoToMyPC to allow our volunteer Treasurer to access the database on the Church's network, in this way she can do her work from home, and not have to worry about file corruption or having out-of-sync data.
Re: Networking Data
Posted: Fri Oct 28, 2005 11:44 am
by Zaphod
melloby wrote:Hi Zapod,
Thx for your reply.
Would this work, if I backup the data on the network. Then I install the data on my remote pc thru the utilities module of PCP+?
Thx
Tamico
When you backup and restore data like that, you run the risk of overwriting data in one place or another, so like NeilZ said, be careful about making updates to the data. It can be done, and lots of folks I talk to do it that way, but you have to take care to not break anything along the way.
Posted: Fri Oct 28, 2005 12:23 pm
by Kristi
Do all your workers use same PowerChurch modules. You are supposed to be able to backup and restore only the modules you want.
Once you get all your information on your offsite. If you are the only person using the Accounting Module. Then backup only the Accounting at offsite and restore only Accounting at work.
However, this isn't a feature I use, so I don't know if it causes problems.
Kristi
Posted: Fri Oct 28, 2005 1:44 pm
by NeilZ
Kristi wrote:Do all your workers use same PowerChurch modules. You are supposed to be able to backup and restore only the modules you want.
Once you get all your information on your offsite. If you are the only person using the Accounting Module. Then backup only the Accounting at offsite and restore only Accounting at work.
However, this isn't a feature I use, so I don't know if it causes problems.
Kristi
Unfortunately, it can, if the contributions are posted directly to the accounting module. In that case, the remote copy would be out of sync.