Using system varibles in custom reports
Posted: Wed Apr 13, 2005 1:57 pm
Hello Everyone,
This is our first go round at using PC+ v9 to write a custom report. (A hundred years ago I used to program in DBase IV).
I need to create a report almost eactly like the (unposted) contribution by fund report. I need one that can filter out the contributions by operator. (We have over 100 contribution funds & anywhere from four to 7 operators). The pre-designed report does not summarize the contribution funds in terms of operator input.
For example I am trying to get a report that will filter by date, contribution fund, & operator. So, that I can audit the input by operators in terms of accurate input into the correct contribution fund.
My question is - is there a varible availiable to capture which operator is doing the input?
I welcome your help,
Tom
This is our first go round at using PC+ v9 to write a custom report. (A hundred years ago I used to program in DBase IV).
I need to create a report almost eactly like the (unposted) contribution by fund report. I need one that can filter out the contributions by operator. (We have over 100 contribution funds & anywhere from four to 7 operators). The pre-designed report does not summarize the contribution funds in terms of operator input.
For example I am trying to get a report that will filter by date, contribution fund, & operator. So, that I can audit the input by operators in terms of accurate input into the correct contribution fund.
My question is - is there a varible availiable to capture which operator is doing the input?
I welcome your help,
Tom