Three Column Report
Moderators: Moderators, Tech Support
Three Column Report
Is it possible to make a report that would have 3 columns, and loop the information alphabetically from column 1 to column 2 to column 3 and then continue on the next page?
Re: Three Column Report
May I ask, what are you trying to do?arcluv wrote:Is it possible to make a report that would have 3 columns, and loop the information alphabetically from column 1 to column 2 to column 3 and then continue on the next page?
Neil Zampella
Using PC+ since 1999.
Using PC+ since 1999.
Re: Three Column Report
I am trying to make a list for our congregation of eligible nominees for our annual elections. The filters for the report are just that they are an active member and they are over age 21. I would just like to configure the report so that the information appears in three columns per page instead of having 9 pages with just one column on each, but I can't figure out if there is a way to 'loop' the information to another column...
Re: Three Column Report
Well .. all you can do is extract the data, save it to a Word document, then manipulate it there.arcluv wrote:I am trying to make a list for our congregation of eligible nominees for our annual elections. The filters for the report are just that they are an active member and they are over age 21. I would just like to configure the report so that the information appears in three columns per page instead of having 9 pages with just one column on each, but I can't figure out if there is a way to 'loop' the information to another column...
Neil Zampella
Using PC+ since 1999.
Using PC+ since 1999.
-
- Tech Support
- Posts: 3017
- Joined: Thu May 13, 2004 9:59 am
- Location: PowerChurch Software
- Contact:
Re: Three Column Report
You can define the number of columns in the custom report by going into the Report Designer, then go to File > Page Setup. Set the number of columns, then check the "Left to right" option instead of "Top to bottom"
Re: Three Column Report
Aha .. will that flow the data ??Zorak wrote:You can define the number of columns in the custom report by going into the Report Designer, then go to File > Page Setup. Set the number of columns, then check the "Left to right" option instead of "Top to bottom"
Neil Zampella
Using PC+ since 1999.
Using PC+ since 1999.